Apprimo Touch 8
Installation and Operation Guide
page 3
Wall Mount Installation
The control panel can be mounted to the wall with or
without a gang box. Most gang box styles are supported.
1. The center of the control panel would typically be
located between 102 – 165 cm (40" – 65") above the
finished floor. Route Cat 5e/6 cable to the location.
There is a channel on the base plate and a knockout
on the angled plate for cable routing if installing on a
solid wall.
Note:
Follow local guidelines for accessible wall controls.
Installations complying with US ADA guidelines the top of
the panel should not exceed 122 cm (48") from the floor.
Remove table mount from the control panel
2. Remove cover from the rear of the table mount.
3. Remove screw holding table mount to control panel.
4. Remove mount by sliding it down and then lifting up.
ACCESSORIES (OPTIONAL)
165 cm
(65")
122 cm
(48")
102 cm
(40")
2
3
4
1
