13
4. FITTING THE HANDLEBAR
STEM.-
Insert the handlebar stem (17) onto
the other stem (54) and onto the boss
on the main body taking care not to
pinch the cables. Connect the cables
from handlebar stem (17) and main
body (1).
Fit the bolts (62) with curved washers
(65), as shown in Fig.4, align the
handlebar stem and hand tighten.
Fit the bolts (64) as shown in Fig.4
and hand tighten.
5. FITTING THE BOTTLE
HOLDER.-
Release the screws (98) on the
handlebar (17), position the bottle
holder (97) and secure it by using the
screws removed previously.
6. INSTRUCTIONS FOR
FITTING THE SADDLE
Next, take the horizontal tube for the
saddle (23) and attach the saddle (74)
to it, Fig.6, tighten the nuts (Z).
VERTICAL ADJUSTMENT
.
In order to raise or lower the saddle
post, first loosen off the control knob
(91) on the saddle post a little by
turning it in an anticlockwise direction,
pull the control knob back and without
releasing it, move the saddle post up
or down, Fig.6. When it is at the right
height release the knob and it will lock
into a hole on the saddle post. Tighten
it up by turning the control knob (91) in
a clockwise direction.
HORIZONTAL ADJUSTMENT
.
To adjust the saddle’s horizontal
position, loosen the control knob on
the saddle’s horizontal bar and move
the saddle, along with the bar, into the
desired position, then tighten the
control knob securely, Fig.6.
TILTING THE SADDLE.
The saddle can be tilted backward or
forward. Loosen off nut (Z) shown in
Fig.6, located under the saddle, tilt the
saddle into the desired position and
then retighten the nut securely.
Do not adjust the tilt of the saddle
while you are still sitting on it.
7. FITTING THE MONITOR.-
Attach the handlebar
（
28
）
into the
bracket of post tube, then fixed the
handle with Allen screw (66), flat
washer
（
65) and spring washer (63)
securely.
Bring the monitor (71) to the
handlebar stem (17) Fig.8, connect
the two terminals coming out of the
handlebar stem (17) and the monitor
(71), Fig.8.
Insert the monitor (71) onto the
handlebar stem (13), as shown in
Fig.8, making sure not to pinch any of
the cables. Fit the bolts (73) making
sure that the handlebar is aligned
correctly, securely tighten all of the
bolts on the handlebar stem including
the bolts at the base which were left
hand tight in point 4.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This is
achieved by screwing the adjustable
foot (51) up or down, Fig.9.
