Tool:
3. Assemble Handlebar
1) Use Allen Wrench to remove two Hexagon Socket Head Bolts (85) from the Handlebar Post (4).
2) Connect upper Hand Pulse Sensor Wire (17) to lower Hand Pulse Sensor Wire (18) at both sides. Hide the
connection into the Handlebar (5).
3) Attach the Handlebar (5) to the metal parts under Computer bracket and tighten two Hexagon Socket Head
Bolts (85) by Allen Wrench. Make sure it’s firm and secure.
4) Release four Self Tapping Screws (57) from the Handlebar (5) by Screwdriver. Cover end of Handlebar (5) with
Handlebar Cover (30) at each side and tighten four Self Tapping Screws (57) by using Screwdriver.
5) Place the Decorate Cover (front) (26) on the Handlebar Post (4).
Tool:
4. Assemble Computer and Decorate Cover
1) Use Screwdriver to remove four Bolts (58) from the Computer (11).
2) Connect Upper Computer Cable (12) and Lower Hand Pulse Sensor Wires (18) with the wires at back of the
Computer (11). Place the Computer (11) on top of the Handlebar Post (4), then tighten it with four Bolts (58) by
using Screwdriver until firm and secure.
3) Connect the Decorate Cover (rear) (26) to the Handlebar Post (4) and tighten it with one Self Tapping
Screws (57) and two Round Head Self Tapping Screws (72).
ASSEMBLY
Allen Wrench
Screwdriver
Screwdriver
- 5 -
Summary of Contents for XS8 -
Page 3: ......
Page 15: ...The HEART RATE CHART is only for the customer reference TRAINING PULSE RATE ...
Page 16: ... 10 18 13 ...
Page 19: ...EXPLODED DRAWING 16 ...