BH FITNESS Tecnovita CELL CONTOUR YS600, User Manual

Page: 45 / 95

45
Always apply an abundant amount of gel to the area that you wish to work. If you need
to purchase gel or any of our creams you can find them in the shop where you
purchased CELL CONTOUR or at our website:
www.tecnovita.eu
Pre-set profiles
CELL CONTOUR has 4 pre-set profiles designed specifically for these body areas:
buttocks, huckle, abdomen, haunch. Click on the icon of the area you want to work.
You will see that the pre-set values of the program will be marked and the hand unit
will be selected. You can modify the intensity by pressing the intensity icon (E) and
then the adjustment buttons (F). Once the body part has been selected and the
intensity adjusted (in case you want to modify it), click on the icon for start / end of the
session (I) to start the cavitation session. Begin to treat the area by sliding the hand
unit slowly and without pressure, as shown in the pictures in the chapter of
Application Modes. You can modify the intensity during the cavitation session by
pressing on intensity adjustment icon (E).
The unit will beep every 30 seconds. If you want to pause the session, click on the
pause icon (H). To return to the session, press the pause icon (H) again.
When the time counter reaches
0.00 the unit will stop and emit a series of beeps to
tell you that the selected session has finished.
Characteristics of the pre-set profiles:
Body part
Infrared LED
(YS800)
Power/Intensity
(W/cm2) Time (min) Mode
Buttocks Sí 4,5 10 Continuo
Huckle No 5 12 Continuo
Abdomen Sí 5,5 8 Continuo
Haunch No 4 10 Continuo