11
exceeded the maximum value, or at the bottom
of the screen in the case of the minimum value,
the monitor will also emit a warning beep.
HAND-GRIP (PULSE)
INSTRUCTIONS - USE
The pulse rate on this model is measured by pla-
cing both hands on the sensors (R), located on
the handlebar, as shown in Figure 7.
When both hands are placed on the sensors the
heart symbol at the top left of the screen will
begin to fl ash and after a few seconds your heart
rate reading will be displayed.
If both hands are not placed correctly as shown
in fi gure 8 then the pulse function will not work.
If, after placing both hands on the sensors as
described in the previous paragraph, the heart
symbol fails to fl ash then check that connectors
(W) and (Y), located at the back of the monitor,
are plugged in correctly.
TROUBLESHOOTING GUIDE
Problem:
The display does not come on, or the
digits are faint.
Solution:
Check the battery charge
Check that the batteries are fi tted correctly.
Problem:
A crossed battery symbol appears on
the screen
.
Solution:
Replace the batteries.
Problem:
Display segments of a function read-
out are not visible or error messages for a parti-
cular function appear.
Solution:
a. Remove the batteries for 15 seconds and
then refi t them correctly.
b. Check the battery charge If they are run
down change the batteries
c. If the above steps do not help then replace
the electronic monitor.
Avoid leaving the electronic monitor in direct
sunlight as this might damage the liquid crystal
display. Similarly, do not expose it to water or
knocks.
BH RESERVES THE RIGHT TO MODIFY THE
SPECIFICATIONS OF ITS PRODUCTS WITHOUT
PRIOR NOTICE
Summary of Contents for H-312
Page 2: ......