17
in. The supply voltage must be
the same as that stated on the
characteristics plate and the
holes in wall socket must match
the pins for plug on the
machine.
2
To reduce the risk of electrical
shock, first put the switch to the
“0” position and then unplug it
from the wall socket. Always
unplug the unit immediately
after use and before proceeding
to clean it.
3
Make sure that the treadmill is
switched off and unplugged
before beginning any type of
maintenance or assembly work
on it.
4
Do not unplug the treadmill by
tugging on the mains cable.
5
Do not use the machine if the
mains cable becomes damaged
or worn.
6
Keep the mains cable away
from hot surfaces.
7
If the power cord is damaged,
contact the customer service for
replacement, in no case should
be handled by unauthorized
persons.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to
protect both the electronic and
electrical circuits.
This safety device will be
automatically triggered if the
unit is subjected to abnormal
force or heat.
Should this occur:
1.-
Set switch (L), located on
the casing, to the “0” (OFF)
position Fig.B.
2.-
Press the circuit button (C)
to reset the unit.
3.-
Next, set switch (L) to the “I”
(ON) position and the unit will
be ready for use again.
Should the circuit breaker trip
repeatedly then the most
probable causes are:
-Abnormal working conditions,
-Treadmill belt in need of
lubricant,
-Solvent based lubricants used
(use BH type),
- Belt is too tight.
Plug the unit into a wall socket
with an EARTH terminal. Set
switch (L) to Position [1].
Fig.B
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
Summary of Contents for G6510O
