23
FAULT FINDING CHART
PROBLEM
CHECKS
SOLUTIONS
The monitor does not switch
on.
1) Make sure that the
machine is plugged in, the
ON/OFF switch in position 1
and that the safety key is
inserted.
1) Plug the machine into the
mains supply. Set the
switch to position 1 and
insert the safety key.
The monitor switches on but
the motor fails to start.
2) Check that the current
limiter is pressed in.
2) Switch the machine off
and
press
the
circuit
breaker in. Lubricate the
treadmill band.
Walking motion is jerky on
the treadmill.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on
the sliding belt.
3.c) Check the tension on
the drive belt.
3.a) Lubricate the sliding
belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
The machine stops (the
breaker trips).
4) Check that the band is
lubricated.
4) Reset the overload
button with the On /Off
switch at „0“ and lubricate
the treadmill band.
Electrical shocks through
the handrail.
5) Check that the machine
is plugged into an earthed
mains socket.
5) Plug the machine into an
earthed mains socket.
The treadmill belt skews off
centre.
6.a) Check that the machine
is level on the floor.
6.b) Check that the machine
does not wobble.
Hesitate to get touch with us if you have any queries, by calling:
902 170 258
Summary of Contents for G6130
