BH FITNESS G2362, Instructions For Assembly And Use

Page: 15 / 57

15
6. FITTING THE FEET.-
Take the right pedal (48R), Fig.4,
(marked with the setter “R”) and slide
it onto the crank shaft on the right-
hand side of the machine.
Now take washer (13-53) and bolt (14)
and tighten securely.
Attach the bottom cover for the right
foot (52), Fig.4.
Take the left pedal (48L), Fig.4,
(marked with the setter “L”) and slide it
onto the shaft on the left-hand side of
the machine.
Now take washer (13-53) and bolt (14)
and tighten securely.
Attach the bottom cover for the left
foot (52), Fig.4.
7. FITTING THE FOOT BARS.-
Take the right foot bar (48R) and
position it on the “U” at the bottom of
the right focus bar (16R), Fig.4. Insert
screw (45), as shown in Fig.4, then fit
the flat washer (27) and the self
locking nut (28), and tighten securely.
Take the left foot bar (48L) and go
through the same assembly procedure
as with the right.
8. FITTING THE FOCUS BAR SIDE
COVERS TO THE FOOT BARS.-
Next fit the footrest covers (47L) &
(47R) with the bottom of the joints on
the right side, Fig.4. Use screws (49)
to screw them together. Then do the
same with the other covers (47L) &
(47R) on the left-hand side.
9. FITTING THE FOOTRESTS.-
Next, remove the screws (50), the flat
washers (39-56) and the nuts (57) and
position the right footrest (51R marked
with the letter “R”) on top of the unit’s
right foot (48R), Fig.5, (left and right
refers to the user’s position doing
exercise) refit the screws (57), the
washers (39-56) and the screws (50)
removed previously and tighten
securely.
Next, position the left footrest (51L
marked with the letter “L”) on top of
the left foot (48L), refit the nuts (57),
the washers (39-56) and the screws
(50) removed previously and tighten
securely.
10. FITTING THE UPPER
FOCUS BARS.-
Take the top left bar (6L) (marked with
the letter “L”). Insert the top bar onto the
bottom left focus bar (16L), lining up the
letters (L), Fig.6, fit the screws (100), the
cap nuts (13-99) and tighten securely.
Now go through the same procedure for
the top right focus bar (6R).
11. FITTING THE HANDLEBAR.-
Insert the hand-grip cable (105) in
through the slot, as shown in Fig.7,
and pull it out through the top of the
focus bar support (24), as shown in
Fig.7.
Take the handlebar (106), remove
screws (20), position the ends of the
handlebar on the plate at the top of
the main post (24), Fig.7. Refit the
screws (20) removed previously.
12. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE.
Take hold of the cable (2), which is
sticking up out of the main post (24),
Fig.8, and plug it into the connector of
the electronic unit (1), as shown in
Fig.8.
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(105), sticking out of the main post
(24), and plug them into the