18
Next, position the left footrest (27L
marked with the letter “L”) on top of
the left foot (31L), refit the nuts (30),
the washers (29) and the screws (26)
removed previously and tighten
securely.
13. FITTING THE HANDLEBAR.-
Take the handlebar (85), remove
screws (12), position the ends of the
handlebar on the plate at the top of
the main post (80), Fig.14. Refit the
screws (12) removed previously.
14. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE.
Take hold of the cable (77), which is
sticking up out of the main post (80),
Fig.15, and plug it into the connector
(96) of the electronic unit (1), as
shown in Fig.15
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(2-2A), sticking out of the main post
(80), and plug them into the
connectors (97-98) located at the back
of the monitor (1), as shown in Fig.15.
ATTACHING THE MONITOR.-
Release screws (84), Fig.15, at the
back of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(80) in the direction of the arrow,
Fig.15, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(84) removed previously.
Take the front (83) and rear (86)
covers and position them on the main
post (80), Fig.16. Now use the screws
(87) to attach them to the post.
ATTENTION:
It is important to
retighten all of the screws involved in
assembling
the
machine
after
approximately a week of use as this
will prevent any strange noises and
possible damage.
LEVELLING.-
Once the unit has been placed into its
fi nal position, make sure that it sits fl
at on the fl oor and that it is level. This
can be achieved by screwing the
adjustable feet (51) up or down, as
shown in Fig.17.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (72)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it,as shown in
Fig.18. Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(92) into the connection hole (k) on the
main body (48) (bottom, rear of the
machine)
and
then
plug
the
transformer into a 220 V mains supply,
Fig.19.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
Summary of Contents for G2336B
