BH FITNESS Aquo R308, Instructions For Assembly And Use

Page: 15 / 22

15
Move the foot rest support (5) towards
the main frame (1) Fig.1.
Insert screws (33), mount the curved
washers (34), and cap nuts (35) and
then firmly tighten with the 6 mm Allen
wrench.
4.- MOUNTING THE ALUMINIUM
RAIL.-
Insert aluminium rail (2) in the
direction indicated by the arrow, into
the central frame (1) Fig.2.
Insert screws (38) with washers (39)
Fig.2 and then firmly tighten with the 6
mm Allen wrench.
5.- MOUNTING THE SEAT.-
Once the aluminium rail has been
assembled, insert seat (27) in rail (2),
in the direction indicated by the arrow,
as shown in figure Fig.2.
Insert the seat travel stops by
mounting screws (40) together with
the end caps (26) and then firmly
tighten with the 6mm Allen wrench.
Mount end caps (21) and (22) at the
end of the aluminium rail as shown in
Fig.2.
6.- MOUNTING THE REAR
SUPPORT.-
Position rear support (3) on the bottom
of rail (2), Fig.3.
Insert screws (38) and washers (39)
and then firmly tighten with the 6mm
Allen wrench.
7.- MOUNTING THE
ELECTRONIC CONSOLE.-
Remove the insulating strip located on
the back of the monitor (27) for
batteries make contact and make sure
the monitor is turned on.
Position the electronic console (27)
next to the seat in the main frame (1)
Fig.5.
Connect the console terminals (32),
with the terminals running from the
main frame (1) Fig.5A, and insert the
console in the seat in the main frame
(1) Fig.5, taking care with the cables.
8.- EXERTION SETTINGS.-
To provide an even level of exertion
during exercise, this appliance is
equipped with a tensioning control
(29), offering various exertion settings,
Fig.6.
To increase exercise resistance turn
the tensioning control (29) clockwise
(+) until the exertion level best suits
your exercise requirements. To reduce
exercise resistance turn the tensioning
control (29) anticlockwise (-).
9.- LEVELLING.-
Once the unit has been placed into its
final position for doing exercise, make
sure that it sits flat on the floor and
that it is level. This can be achieved by
screwing the adjustable support
blocks (24) up or down, as shown in
Fig.6.
10.- MOVEMENT & STORAGE.-
The unit is equipped with wheels (14)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.4. Store your unit in a dry place,
preferably not subject to changes in
temperature.