15
FAULT FINDING CHART
PROBLEM
CHECKS
SOLUTIONS
1. The monitor does not
switch on.
1) Make sure that the machine
is plugged in, the ON/OFF
switch in position 1 and that
the safety key is inserted.
1) Plug the machine into the
mains supply. Set the switch
to position 1 and insert the
safety key.
2. The monitor switches on
but the motor fails to start.
2) Check that the current
limiter is pressed in.
2) Switch the machine off and
press the circuit breaker in.
Lubricate the treadmill band.
3. Walking motion is jerky
on the treadmill.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the
drive belt.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
4. The machine stops (the
breaker trips).
4) Check that the band is
lubricated.
4) Reset the overload button
with the On /Off switch at „0“
and lubricate the treadmill
band.
5. Electrical shocks through
the handrail.
5) Check that the machine is
plugged into an earthed mains
socket.
5) Plug the machine into an
earthed mains socket.
6. The treadmill belt skews
off centre.
6.a) Check that the machine is
level on the floor.
6.b) Check that the machine
does not wobble.
Do not hesitate to get touch with the Technical Assistance Service if you have any queries by phoning
customer services (see last page in manual).
Summary of Contents for 3265707
