BH FITNESS 2269939, Instructions For Assembly And Use

Page: 14 / 56

14
5.- FITTING THE ALUMINIUM
RAIL.-
Insert the aluminium rail (52) onto the
main body (1) in the direction of the
arrow, Fig.3.
Fit the bolt (103) in the direction of the
arrow, along with the nut (105)
removed previously, Fig.3 and tighten.
Fit the nut cap (79), Fig.3.
Remove the screw (101) along with
the nut (105) from the “U” piece on the
main body (1). Position the retaining
bar support (60) on the “U” piece and
tighten using screw (101) removed
previously.
Lift the aluminium rail that you have
just fitted as shown in Fig.4.
Pull the knob (59) back and lift the
support so that the bolt holes line up,
fit the bolts (97) and tighten securely.
6.- FITTING THE SADDLE.-
First, Fig.5, take the saddle support
(64) and pull the knob (67) outward,
Fig. E, twisting it so that it locks into
position.
Position the saddle (68), Fig.5, on the
saddle support (64), Fig.F, lining up
the holes and secure using screws
(95).
Remove the saddle stop (54), Fig.7,
and once you have fitted the saddle
insert it into the aluminium rail as
shown in Fig.6, when it reaches the
rack (N) turn the knob (67) and
release it so that it slots into one of the
openings on the rack, preventing the
saddle from moving on the aluminium
rail.
Fit the saddle stop screw (54)
removed previously and fit the end
cap (55), as shown in Fig.7.
7.- FITTING THE REAR
SUPPORT.-
Position the support (60) at the top of
the rail, Fig.6.
Fit the bolt (102) with its nut (105),
Fig.6, and tighten securely.
Fit the nut cap (79), Fig.6.
8.- LOCKING PIN.-
Fit the locking pin (63) onto the
support as shown in Fig.7.
IMPORTANT: Making sure that this
locking pin (63) is fitted into its locking
position, both when the machine is
folded and ready for doing exercises.
9.- LEVELLING.-
ATTENTION: Make sure that the
machine is levelled correctly before
attempting to do any exercise on it.
Pull out the locking pin (63) and swing
the rear support (62) upward so that it
lines up with the holes, reinsert the
locking pin (63).
Next, hold the aluminium rail with one
hand and with the other pull on the
knob (59), Fig.7, carefully lowering the
rail down onto the floor, Fig.8.
Make sure that you have heard the
retaining knob (59) click into place
when you lower the rail.
If you do not hear it click into place
then pull the adjuster (43), located at
the bottom of the main body (1), down
toward the floor so that the knob (59)
locks into position, as shown in Fig.8.
If you hear it click into position before
the rear support (62) is resting on the
floor, Fig.8, push the adjuster (43) in
so that the three points are all level on
the floor, Fig.8.