BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
OPERATION
1. Lubricate the tool before operating. See “CARE AND MAINTENANCE”
section for oiling instructions.
2. Disconnect tool from air supply. (Fig.7)
3. Screw tight by hand at clockwise direction the sanding pad into the female
thread of the bearing stand (Part #21) while holding the provided wrench on
the flats of the stand as shown. (Fig.1)
4. Mount a sanding paper (not provided) onto the sanding pad.
5. Connect the dust tube to the dust tube connector (Part #32) and set it
secure. (Fig.2)
6. Mount the dust bag to the dust tube by tying the string tight around the tube
end. (Fig.3)
7. Remove the air cap from the tool air inlet and connect the air supply hose to
the tool. Set the air pressure at 90 PSI(Fig. 4)
WARNING
: When connecting
the air hose, keep the speed control knob (i.e. trigger valve - Part #26) in
“OFF” position by turning the knob backwards to the upmost. (Fig.5)
8. Turn the speed control knob forwards to the upmost, hold the tool by one
hand and slowly press down on the trigger by your palm to the upmost.
Then the tool starts to work. (Fig.6)
NOTE:
You can control the air flow and
rotation speed by turning the speed control knob.
REPLACEMENT OF SANDING PAD
1. Disconnect the tool from air supply. (Fig.7)
2. Rotate with hand counter clockwise the sanding of the female thread of the
bearing stand while holding the provided wrench on the flats of the stand.
3.
Replace a new sanding pad in the same way as said at the above Point 3 in
“OPERATION INSTRUCTIONS” section.
WARNING
: Only use sanding
pads that have an RPM rating equal to or greater than the tool itself
.
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
