BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 8688
Air Eccentric Grinder
TECHNICAL DATA
Grinding disc size: 152 mm (6")
Grinding disc holder with 6 holes
Shaft thread: M8 x 1,0
Free speed: max. 10,000 rpm
Working pressure: 6.3 bar (90 psi)
Air consumption: 142 L/min
Air inlet: 1/4"
Pressure hose: 10 mm (3/8") (ID)
Weigth: 1050 g
Overall lenght: 225 mm
Sound pressure level LPA: 87dB (A)
Sound power level LWA: 98dB(A)
Vibration level: ah=8.5 m/s² / K=1.5 m/s²
WARNING!
Read, understand and follow all instructions and warnings before operating this tool.
Failure to do so may result in personal injury and/or property damage and will void warranty
.
SAFETY INSTRUCTIONS
•
Oil tool before each use 4 to 5 drops of a good grade air tool oil
.
•
Use proper air pressure and CFM rating listed for this tool
.
•
Be sure the air tool is in OFF position when connecting the tool to air supply
.
•
Always wear approved eye protection when using tools.
If
raising dust, wear a suitable mask
.
•
Use only accessories which are designed for using with air tools
.
•
Be sure to disconnect tool from air supply before changing accessories, performing service on
tool, and when not in use
.
•
Use common sense when operating this air tool. Do not wear loose clothing or
jewelry
that
could become caught by moving parts, causing injury
.
•
Operate this air tool only in a safe distance from yourself and others persons.
•
Follow the instructions of the air source manufacturers for connection of regulators, filters, and
other accessories to air source.
•
Bewahren Sie das Gerät außerhalb der Reichweite von Kindern auf.
•
Lassen Sie Kinder nicht mit dem Druckluftwerkzeug oder dessen Verpackung spielen.
AIR SOURCE
Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of 90
PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.
Water in the air hose and compressor tank contributes to reduced performance and damage of the air
tool. Drain the air tank and filters before each use and as necessary to keep the air supply dry. Use
an in-line pressure regulator with gauge if air inlet pressure is critical.
