BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
SUPPLY TO 220V DEVICES
This inverter uses a modified sine waveform, which is not quite the same as power company electricity.
We strongly recommend that you check the device’s manual to make sure it is compatible with modified
sine waveform. It is important to know the continuous wattage of the device you plan to use with the
inverter. This device must be used with devices drawing 400 watts or less. Devices like TVs, fans or
electric motors require additional power to start (commonly known as the “starting or peak power”). This
device can supply a momentary surge in wattage; however even devices
rated less than the maximum 400 watts can exceed the inverter’s surge capability and cause an automatic
overload shutdown. If powering more than one device, start one device at a time to avoid a power surge
and/or inverter overload. The surge load of each device should not exceed the inverter’s Continuous
Operation wattage rate.
POWERING A 220V AC DEVICE
Plug the device into one of the two 220V AC household power outlets on the front panel. Press 220V
power outlets On/Off button first then turn the device on.
Note
: When the potable power unit acts as the
power inverter, it features the low voltage protection for itself (with alarm sound to remind the user when in
protection), short circuit protection, overheat protection and overload protection.
RISK OF ELECTRIC SHOCK
Incorrect operation of your inverter may result in damage and personal injury. The inverter output is 220V
AC and can shock or electrocute the same as any ordinary household AC wall outlet.
AIR COMPRESSOR
Read the instructions of the product being inflated before using the compressor. Avoid over-inflation; do
not exceed the manufacturer’s recommended pressures. Do not leave the air compressor unattended
during use.
1. Remove the air compressor hose from the storage compartment in the back of the device.
2. Connect the adapter to the valve stem and close the thumb latch. If necessary, use one of the
additional adapters.
3. Press Air Compressor On/Off button to start power and observe the air compressor gauge until it
reaches to the desired pressure you need. Do NOT leave the air compressor unattended during
inflation.
4. Open the thumb latch and remove the connector from the valve stem.
5. Do not run for more than 10 minutes at a time. Allow the jump starter to cool down for 10 minutes
before using again.
6. Wrap the compressor hose around the cleats when it is not being used.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and
packaging should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment.
DISPOSAL
Do not dispose battery in household waste. Batteries should be disposed of in a responsible
manner, they must be disposed at appropriate collection point. Dispose of this product at the
end of its working life in compliance with the EU Directive on Waste Electrical and Electronic
Equipment. Contact your local solid waste authority for recycling information or give the
product for disposal to BGS technic KG or to an electrical appliances retailer.
