13
Error Conditions and Display Codes
Error conditions
Errors are identified by Error Messages, normally after a crimp cycle.
Table 1
Error codes
Error
Possible cause
Recommendation
Stall
Stall Condition – Crimp
Setting is too high.
Adjust crimper to a lower crimp setting by pressing the
button.
Stall Condition – Battery
does not have sufficient
charge.
Recharge battery.
Early Button
Release
Early trigger release – the
tool retracted before
completing cycle.
Try again, making sure to hold the button down until the
tool is returning to the home position.
Stall but tool does
not cycle.
Motor drive failure.
See Maintenance/Repair section for contact information for
warranty and repair service information.
Battery low
Indicator
Battery needs to be
charged.
Charge battery (See Page 8).
Battery low
indicator (after
charging 24 hours)
Charge Circuit Failure
See Maintenance / Repair section for contact information
for warranty and repair service information.
