BG CARDIO 80i Fold Flat, Owner'S Manual

Page: 21 / 32

18
3G
CARDIO
www.3GCardio.com
CUSTOM PROGRAMS
•
When treadmill is stopped, press [USER PROG] to enter into Custom Program, set speed and incline first and then adjust the time.
• A Custom Program is divided into 16 sections. Set speed and incline for each individual segment.
• After you finish setting the desired speed and incline for all 16 section, then use the Quick Dial to adjust time. Turn the Quick Dial
to adjust your desired total workout time then press the Quick Dial to finish.
• Press [START] to begin your workout.
• Treadmill will save your program in its memory. The treadmill will begin with the most recently set program unless it has been reset.
• When the time countdown reaches zero the workout is over and the treadmill will stop running.
HEART RATE
Hold the hand-pulse grips which are located on the left and right handlebars at the same time, it will take 5-10 seconds to register. Your
heart rate will be displayed on the [PULSE] part of the console.
AUTOMATIC SHUTDOWN
The treadmill will automatically shutdown after 10 minutes of being idle. Press any key to start up again.
STOP
Press [STOP] to stop the treadmill. Press [PAUSE], to temporarily stop the belt movement but maintain your current workout stats.
The treadmill will stay paused for 10 minutes. The treadmill will stop if you remove the safety key.：
Turning off the power will cause the treadmill and belt to shut off.
Troubleshooting
1. Self-Diagnostic Error Messages and Solutions
• Display：E01 — E01：Console is sending command to controller but controller feedback information to console is obstructed.
Solution:：Check if the console is connected to the control unit or if the 4-wire connector is loose or damaged.
• Display：E02 — E02：The motor line voltage has not been tested by controller. Solution:：Check whether motor positive/negative
wire connection to controller terminal is tight.
• Display：E03 — E03：The speed feedback information has not been tested by controller while motor is running. Solution:：Check the
hole on the disc to make sure it’s lined up with the light and electronic sensor.
• Display：E05 — E05：The electrical current or running belt friction is too high and the motor has exceeded rated current. Solution:
：Check running belt lubrication or check motor for damage. You may have to change the motor.
2. Other Problems and Solutions
• Data not visible on the console — Check whether power cord is connected, power switch is opened, SMD fuse has blown out.
Check connection from the console to the control unit’s 4-wire connector. Check if controllers and transformers are connected.
• Hand pulse not visible or ‘error’ is in the display. — Check hand pulse wire and make sure it is tight. Make sure both hands are
on the left and right sensors at the same time. Use water to wash hands, keep humid.
• Motor won’t start. — Make sure all wires are connected. Observe the fault information on the console.
• Display color/contrast and text — LCD: Check if LCD’s press frame is tight, or remove press frame and clean the copper part on
the PCB. LED: Check if LED pin weld is intact.
Console Operation and Programming 80i FFT