14
Warning: The capacity of the suction bottle is 1L. However, it is recommended
to empty and clean the suction bottle after each use. Suction bottle should be
cleaned out before exceeding 500 ML point or risk of contamination may occur
if suction gathered fluids spill.
Instrument and hose Cleaning Bottle I/ Bottle II
In order to reduce the amount of bacteria in the waterline,
water can be used to clean the treatment instruments air
water syringe
Frequency of cleaning
Daily before starting the work day and again, at the end of
the work day.
Air water syringe
a. Take out the air water syringe from the holder
b. Put the air water syringe over a sink or a bucket
c. Press the water button of the air water syringe for 20-
120 seconds (until water no longer sprays from the tip)
d. Put the air water syringe back on the holder
Handpiece Cords
1. Remove the High Speed Handpiece and Low Speed
Handpiece from the holder
2. Disconnect the handpiece from the tubing cord
3. Adjust the water regulator for all equipment to
maximum flow
4. Put the treatment cords over a sink or a bucket
5. Step on the foot pedal for 20 to 120 seconds to wash
the waterline of the treatment instrument
6. Put the handpieces back on the holder
Foot Pedal
Improve its stability by regularly cleaning the foot switch
•
Clean the pedal by a damp cloth or water
Dirt cup
The instrument oil is collected in the dirt cup
•
The dirt cup needs to be clean after daily use
•
Clean the dirt cup weekly with a mild commercial cleaner
Suction system
(Model C2 and C4
do not have this
function)
1. Put 0.6L of cleaning liquid into a separate container and
mix well
2. Remove the extraction handle and start suction to make
the cleaning solution work. Pay attention to the cleaning
solution time specified by the manufacturer.
3. Drain the suction bottle cleaning solution and clean the
suction plastic bottle, reinstall the equipment.