Chapter 8. Config. Network Settings
IP Video Door Station DS06M(P) Operation User Manual
39
Allow registration:
Allow the door station to be registered in the SIP server. Disabled by
default.
Get the address of a registration server via DHCP:
Check to enable this option. SIP server
must support this function.
Registration server/Port:
The network address and port of the registration server. The
network address may match the SIP server address. These fields are empty by default.
Get the address of a proxy server via DHCP:
Check to enable this option. SIP server must
support this function.
Proxy Server/Port:
network address and port of the Proxy server.
SIP Server/Port:
network address (for telephone exchange) and port (for data exchange) of
the SIP server. These fields are empty by default.
NAT:
the door station operates via a STUN server. STUN server is one of the secure ways of
getting access to devices within the network that are behind NAT. Disabled by default.
STUN IP/STUN port:
network address and port of the STUN server.
ATTENTION!
STUN does not work properly with symmetric NAT. When using symmetric NAT the IP address of the
STUN server will differ from the endpoint address. Therefore the NAT address seen by the STUN server
will also differ from the endpoint address used for sending data to the user agent..
DTMF Mode:
select DTMF signal transmission mode. Available modes:
RFC2833
– send DTMF tones within RTP packages.
In-Band
– DTMF signals are found in the media stream; G.711 alaw/ulaw only.
SIP INFO
– send DTMF tones within INFO-messages.
Stream Type:
Select the type of stream transmitting during SIP sessions between the Guest
and the Client. Applied for both accounts. The main stream is selected by default.
“Audio only” is also
available.
Call subscriber when pressing
“Call” button:
Call recipient by pression the
“Call” button on
the door station panel. This function is disabled if no Call recipient is selected.
Call account:
call recipient(s) by pre
ssing the “Call” button. «SIP 1» is selected by default. If
SIP 1 is not available, the value switches to
«SIP 2» (and vice versa).
Call Recipient 1-5:
Select the recipients
that must be called when the “Call” on the door
station is pressed. These fields are empty by default.
Relay Out 1-3 (DTMF):
set the value of the DTMF signal. The relay outputs will close when
the signal is received. For example, the door will open when the specified phone button is pressed.
Up to 3 DTMF symbols are available (0-9, #, *). These fields are empty by default.