!
WARNING:
This symbol refers to a potential hazard or unsafe practice, which could result in
serious injury or death.
!
!
!
DANGER:
This symbol warns of imminent hazard which may result in serious injury or death.
!
!
CAUTION:
This symbol refers to a potential hazard or unsafe practice, which may result in minor or
moderate injury or product or property damage.
!
!
NOTICE:
This symbol refers to information that needs special attention or must be fully understood
even though not dangerous.
GENERAL INFORMATION
THIS MANUAL SHOULD BE RETAINED FOR FUTURE REFERENCE
The
takes pride in the design and quality of our products. When used as intended and
with proper care and maintenance, you will experience years of reliable operation from this equipment. To
ensure best results, it is important that you read and follow the instructions in this manual carefully.
Installation and start-up should be performed by a qualified installer who thoroughly read, understands and
follows these instruction.
If you have questions concerning the installation, operation, maintenance or service of this product, write
Technical Service Department
Before installing and operating this equipment be sure everyone involved in its operation is fully trained and
aware of all precautions. Accidents and problems can result by a failure to follow fundamental rules and
precautions.
The following words and symbols, found in this manual, alert you to hazards to the operator, service
personnel or the equipment. The words are defined as follows:
BevLes Company
BevLes Company, Inc., 729 ThirdAvenue, Dallas, TX 75226
SAFETY PRECAUTIONS
!
CAUTION:
These models are designed, built, and sold for commercial use. If these models are
positioned so the general public can use the equipment make sure that cautions, warnings, and
operating instructions are clearly posted near each unit so that anyone using the equipment will
use it correctly and not injure themselvesor harm the equipment.
!
!
WARNING:
Check the data plate on this unit before installation. Connect the unit only to the voltage
and frequency listed on the data plate. Connect only to single phase as listed on the data plate.
!
!
!
WARNING:
Electrical and grounding connections must comply with the applicable portions of the
national electrical code and/or other local electrical codes.
WARNING:
Install per the spacing requirements listed in the installation section of this manual. We
strongly recommend having a competent professional install the equipment.A licensed electrician
should make the electrical connections and connect power to the unit. Local codes should always
be used when connecting these units to electrical power. In the absence of local codes, use the
latest version of the National Electrical Code.
!
!
!
!
WARNING:
This device should be safely and adequately grounded in accordance with local
codes, or in the absence of local codes, with the National Electrical code, ANSI/NFPA 70, Latest
Edition to protect the user from electrical shock. It requires a grounded system and a dedicated
circuit, protected by a fuse or circuit breaker of proper size and rating. Canadian installation must
comply with the Canadian Electrical Code, CSAC22.2, as applicable.
2
!
!
WARNING: This appliance must be serviced by an Authorized Service Technician only.
Before cleaning or servicing the unit, disconnect device from electrical power supply and
place a Tag Out-Lockout on the power plug, indicating that you are working on the circuit.
