Better Water EQROPB01600, Operator'S Manual

Page: 35 / 84

Better Water LLC; rev. Jul 2019
Page 31 of 80
PB2
– Mediport Portable RO Operator Manual
3.
Verify that all air has been purged from the PB2’s pre-treatment as detailed in the “
Unpacking
and Initial Start-
Up” section.
4. Turn the OPERATE Switch to the OPERATE position.
- If the PB2 goes into Low Pressure Alarm, press the LOW PRESSURE ALARM RESET Button .
If it continues to go into Low Pressure Alarm, see
“ Low Pressure Alarm” Section.
- The PB2 should start up and the Water Quality Monitor should go into poor water quality
condition. Verify that while in this condition the following is happening:
-
No product water should be coming out of the Green Tubing from the “PRODUCT OUT”
port.
- Product water
is being diverted to drain through the Red Tubing from the “TO DRAIN”
port.
-
The “Good Water Quality” LED indicator is not lit.
- Once the Water Quality Monitor gets above the set-point it should go into a good water quality
condition. Verify that while in this condition the following is happening:
-
The product water should flow from the Green Tubing from the “PRODUCT OUT” port.
-
No product water should be diverting to drain through the Red Tubing from the “TO
DRAIN” port.
-
The “Good Water Quality” LED indicator should be lit.
- If it is not functioning as described, recheck setup/install, and if necessary contact Technical
Support.