Bekamatic
®
Industry
ed. April 2006 ENGLISH
19/21
Step 4: Repeat step 1 to 3 for the other transmitter on the guiding post.
Step 5: If the alignment is well performed both transmitters will only cover their own
receiver.
Step 6: Repeat step 1 to 5 for the transmitters on the end post.
Tip: if the photocells suffer from interference with sunlight and/or other light sources,
it is recommended to align the receiver so that is ‘looks down’ from the straight line
between the receiver and the transmitter.
12. Start the Self-Learning procedure
ATTENTION!
During the self-learning cycle, the gate measures the time needed for one full cycle (open
– close or close – open). This time is stored into the non-volatile memory of the controller and
will be used as the motor protection. The first time a time-out occurs E7 will be indicated on the
controller display, the second time E5 will be indicated.
When error code E5 is indicated, it
is necessary to investigate the cause of the time-out. A simple reset of the controller
and a new trigger for gate movement may cause irreversible damage of the drive
unit.
A new gate will always have done a self-learning cycle as a test when manufactured (otherwise
E9 will be indicated). Nevertheless we strongly advise to redo the cycle. Note that during the
cycle all safety devices are active, so take care not to trigger accidentally one of the safety
devices.
To start the self-learning, the controller must first be put in configuration mode and then in
special function mode. Configuration mode is indicated on the controller by a blinking decimal
point on the right-hand display. Special function mode is indicated by two blinking decimal
points.
60761BM IM Ind_ENG.indd 19
60761BM IM Ind_ENG.indd 19
08-05-2006 09:11:19
08-05-2006 09:11:19
