Bekamatic
®
Industry
ed. April 2006 ENGLISH
11/21
3. Close the gate nearly completely by hand and align the
lock post. Make sure that the guiding rolls on top of the
wing are entering the catcher in the middle. Forcing on
one of the sides when adjusting is not tolerable.
4. Put the wing in the position that the rear guiding wheels
and the guiding wheels at the position of the guiding
post support it. Put a level in the middle between these
sets of guiding wheels. If necessary bring to horizontal
position by lowering or raising the rear guiding wheels
support by means of the nuts of the ground anchors.
Make sure to preserve the horizontal level of the base
plate.
WARNING!
IN ANY CASE DO NOT ADJUST WITH
THE M10 NUTS AND BOLTS FOR THE
CONNECTION OF THE BASE PLATE
AND THE WHEEL SUPPORT.
5. After alignment of the lock post and horizontal leveling
of the wing, adjust the height of the lock post so that
the support wheel under the front of the under beam is
slightly touching the ramp (of the lock post) just below
the horizontal surface. Beware to keep the vertical
levels and the positioning in the catcher of the lock
post. The height adjustment is done with the nuts of
the ground anchors.
IMPORTANT!
The support wheel in the under beam may not force from complete down position on the
ramp to enter the lock post.
6. After full adjustment of the gate, tension up all nuts from the ground anchors. Then cut
the lengths of the ground anchors 1/2 cm above the nuts, and paint afterwards against
corrosion.
60761BM IM Ind_ENG.indd 11
60761BM IM Ind_ENG.indd 11
08-05-2006 09:11:15
08-05-2006 09:11:15
