MAINTENANCE
• Make sure that the Filter Pump is unplugged before any maintenance.
• For the maintenance instructions, refer to illustration steps inside the manual. Drawings are for illustration purposes
only. May not reflect actual product. Not to scale.
• To optimize the Filter Pump performance and for sanitary reasons, we suggest replacing the filter cartridge with a new
one every two weeks.
INSTALLATION
SETUP
CHECK LIST
To check the parts included in the box, consult the part list inside this manual. Verify that the equipment components
represent the model that you had intended to purchase. In case of any damaged or missing parts at the time of purchase,
visit our website bestwaycorp.com/support.
CHOOSE THE CORRECT LOCATION
Place the Filter Pump on a solid and level ground; it must be positioned on the same level as the base of the pool. If the
Filter Pump is in an upper or lower position than the base of the pool, the performance and life span of the Filter Pump can
be compromised. The pool and the Filter Pump have to be positioned in an area with adequate drainage and easy access
for maintenance operations. Never place the Filter Pump in a area that may accumulate water.
ATTACHING A BASE
FOR 330GAL
EN60335-2-41 TEST standard requires the filter pump to be vertically fixed
on the ground or a base made of wood or concrete before use. There should
be two holes 9 mm in diameter on the base, the space between which
should be 127 mm. Put filter pump on the base and attach them together
by fastening the bolts and nuts. All the base parts should weigh at least
over 18 kg to prevent the pump from accidentally falling.
5
390 127
40
390
250
127
2-M8 nut
2-M8 bolt
FOR 530GAL
EN60335-2-41 TEST standard requires the filter pump to be vertically fixed
on the ground or a base made of wood or concrete before use. There should
be two holes 9 mm in diameter on the base, the space between which
should be 159 mm. Put filter pump on the base and attach them together
by fastening the bolts and nuts. All the base parts should weigh at least
over 18 kg to prevent the pump from accidentally falling.
390 159
40
390
250
159
2-M8 nut
2-M8 bolt
FOR 800GAL
EN60335-2-41 TEST standard requires the filter pump to be vertically fixed
on the ground or a base made of wood or concrete before use. There should
be two holes 9 mm in diameter on the base, the space between which
should be 166 mm. Put filter pump on the base and attach them together
by fastening the bolts and nuts. All the base parts should weigh at least
over 18 kg to prevent the pump from accidentally falling.
390 166
40
390
250
166
2-M8 nut
2-M8 bolt
WARRANTY TERMS
For information concerning warranty terms, visit our website at: www.bestwaycorp.com.
STORAGE
• Remove all accessories; be sure that Filter Pump, hoses and debris screens are completely clean and dry before the
storage. If all the parts are not completely dry, mold may result.
• Before storage, remove and dispose of the filter cartridge.
• We strongly recommend disassembling the Filter Pump when the environment temperature is below 10ºC / 50ºF.
• Store the Filter Pump in a dry place with a moderate temperature between 10ºC / 50ºF and 38ºC / 100ºF.
• For the installation instructions, refer to the illustration steps inside the manual. Drawings are for illustration purposes
only. May not reflect actual product. Not to scale.
• Bestway will not be responsible for any damage caused to the Filter Pump due to mishandling or failure to follow these
instructions.
• It is imperative to check that the hydraulic connectors are not obstructed.
• Do not dry run the Filter Pump. Make sure both the pool's inlet and outlet valves are fully covered by water before
operating the Filter Pump.
