6
Repair
Check pool for any leaks from valves or seams, check the ground cloth
for any evident water loss. Do not add chemicals until this has been
done.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter
clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in
the area where you are going to drain your pool. (Check local
regulations for drainage by-laws).
3. Screw the control ring of the hose adaptor clockwise onto the drain
valve. The drain valve will be open and water will start to drain
automatically.
ATTENTION:
Water flow can be controlled with the control ring.
4. When draining is finished, unscrew the control ring to close the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Do not leave the drained pool outside.
Storage and Winterization
1. Please remove all the accessories and spare parts of the pool and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together, fold pool carefully. If pool is not completely dry,
mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as per above instructions also.
5. Improper draining of the pool might cause serious personal injury and/or damage to personal property.
6. We strongly recommend the pool is disassembled during the off season (winter months). Store in a dry location out of children’s reach.
Parameters
Water clarity
Colour of the water
Turbidity in FNU/NTU
Nitrate concentration above that of fill water in mg/l
Total organic carbon (TOC) in mg/l
Redox potential against Ag/AgCI 3,5 m KCl in mV
pH value
Free active chlorine (without cyanuric acid) in mg/l
Free chlorine used in combination with cyanuric acid in mg/l
Cyanuric acid in mg/l
Combined chlorine in mg/l
Values
clear view of the pool bottom
no colour should be observed
max. 1,5 (preferably less than 0,5)
max. 20
max. 4,0
min. 650
6,8 to 7,6
0,3 to 1,5
1,0 to 3,0
max 100
max 0,5 (preferably close to 0,0 mg/l)
IMPORTANT:
Don't use granulate tablets or throw the tablet directly in the water. The chemicals can deposit on the bottom, damage the material
and discolor the PVC.
Using chemical liquid (not included):
IMPORTANT:
Add chemical liquid in small doses and in the center of the pool to avoid direct contact between the chemicals and the PVC surface.
Direct contact can damage the material and discolor the surface.
NOTE:
Remove the chemical dispenser from pool when the pool is in use.
IMPORTANT:
After performing chemical maintenance and before using the pool, use a test kit (not included) to test the water chemistry. We
recommend maintaining your water according to the following table.
NOTE:
Damage resulting from chemical imbalance is not covered by the warranty. Pool chemicals are potentially toxic and should be handled with
care. There are serious health risks from chemical vapors and the incorrect labeling and storage of chemical containers. Please consult your local
pool supply retailer for more information about chemical maintenance. Pay close attention to the chemical manufacturer's instructions. Pool
damage resulting from misuse of chemicals and mismanagement of pool water is not covered by the warranty.
Important:
Over usage of chemicals can discolor the printing and all points of the pool material. It can also damage the structure of the pool liner.
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals and pH kits. One of the most important factors to increase the life of
the liner is to keep continuously clean and healthy water. Please strictly follow the instructions from professional technicians for the water
treatment through the use of chemicals.
2. Locate a bucket of water next to pool to clean users’ feet before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Check and wash the filter cartridge regularly.
6. Gently clean any scum from below the top ring with a clean cloth.
7. Please be careful in case of rain water, kindly check that the water level is not higher than the expected. If so, YOU HAVE TO DISCHARGE THE
EXCESS WATER.
8. If it rains, check that the water level is not higher than the specified level. If water exceeds the specified levels, drain the pool to the specified level.
Proper maintenance can maximize the life of your pool.
During the season of use of the swimming pool, the filtration system must be necessarily put into service every day, enough time to assure at least
a complete renewal of the volume of water.
NOTE:
The pump is used to circulate the water and to filter small particles. In order to keep your pool water clean and hygienic, you must also add
chemicals.
Jet Nozzle Maintenance
1. Twist untill hearing a “click” sound, and pull out the Jet Nozzle to clean the debris.
2. Insert and twist clockwise to put it back.
