Rev. B 1112
54823 pg. 4
Supertop NX Twill Installation Instructions
Remove and save the screws that attach the fabric tabs and cable
brackets to the ends of the Header.
Loosen the outboard screw on the top side of the Header.
Insert the Right Side Bow into the right side of the Header and secure
it to the molded Lower Header with two #8 X 1/2" Pan Head Washer
Screws.
Secure the Top Steel Header to the Side Bow with two #8
X 1/2" Pan Head Washer
Screws and tighten the
outboard screw that was
loosened.
Reconnect the fabric cable
bracket and fabric tab.
Repeat on the left side.
Install Bow Mount Brackets
on Sport Bars
Driver’s Side Shown
Use Bow Mount Screws to install Bow Mount
Brackets on rear sport bar.
Rear
Install Side Bows on
Header Assembly
Release Fabric Tab
and Cable Bracket
Side Bow
Upper
Header
#8 X 1/2" Pan Head
Washer Screws
Remove the paper on the adhesive backing on
the Front Top Arch. Insert one end of the Arch in
to the slot in the middle of one of the Front Door
Rails. Push the other end inward to flex the bow
and insert it into the slot on the other side of the
vehicle.
Repeat with the Rear Top Arch.
Install Top Arches
Lower
Header
Install Tailgate Bar Mounts
Locate the left and right Tailgate Bar Mounts. Orient
them on the vehicle. Hook the bottom of one mount
under the belt rail and roll it toward the inside of the
vehicle until it clips into place. Repeat this with the
other Tailgate Bar Mount.
