51440/51443 11
Rev. C 0301
Door Strike Installation
Note: If a hard door strike is present, it must be removed.
Note: Some vehicles will use the existing holes and bolts from the hard door strike.
Close the door against the body and locate the Door Strike behind the Paddle Handle
Latch. Mark the center of the slots in the Door Strikes. Center
punch and drill two 3/16 inch holes. Secure the Door Strikes with
two #14 Sheet Metal Screws. The Door Strikes may be adjusted
in or out until you are satisfied with the way the door shuts and
opens. Tighten the machine screws on the
Paddle Handle and trim any excess fabric from
around the Paddle Handles.(Leave 1/4 inch of
fabric around the inside of the Paddle
Handle.)
Adjusting the Top
Rear Curtain
To roll up the Rear Curtain, start at the bottom and roll it to the inside. Avoid wrinkles in
the fabric and window. Secure it in place with the curtain strap inside of the top (see
Figure 12).
Figure 12
Figure 11
Door Strike
Detail of Rear
Curtain
Curtain Up
Curtain Down
Strap
Rear Window
Fabric
Side View
Screws
Area detailed
at right
