P13 - 44943 Rev. A 1216
Installation Instructions - Rear Tire Carrier
© 2016 Bestop, Inc.
Page 13
Step 1
Step 2
Hardware
Tools
482.06
Section 9
Attach Brake Light
Step 1
Step 2
Take the connector and wires that you cut
to 24” in an earlier step, and feed the wires
through the Tire Carrier Post, Tire Mount
Receiver, and Tire Mount.
Use the two Butt Connectors supplied in the
Light Kit #482.06 to connect the two stripped
wire ends to the two bullet connectors on the
Light Kit pigtail.
Using a coat hanger or something similar may
make threading the wires through the Tire
Carrier Post and Tire Mount easier.
Feed the wires back through the Tire Mount
and press the rubber boot on the Light
housing into the center hole in the face of
the Tire Mount.
Wire Stripper-
Crimper
Light Kit
Part #482.06
Qty. 1
Includes 2 Butt Connectors
