- 8 -
Plug hood power cord into the outlet.
Slide a 8” round metal duct over the adapter/damper. Use metal foil duct tape to seal
the joint.
9. INSTALL ADAPTER/DAMPER (SINGLE BLOWER MODELS ONLY)
(CONT’D)
HJ0037
10. INSTALL THE ADAPTER AND THE DAMPER (DUAL BLOWER MODEL ONLY)
Remove the adapter and the damper from the top of the hood (keeping them together) and slide the
10” round metal duct over the adapter/damper. Secure the adapter/damper to the duct with
3
no. 8
sheet metal screws (not provided). Check to make sure damper opens and closes freely. Seal all joints
with metal foil duct tape to eliminate air leaks.
Place the adapter on top of the hood by aligning its screw
holes to those of the hood (
1
). Do not screw the adapter on.
Slide the damper over the adapter, placing its hinge parallel to
the range hood sides (
2
).
In order to seal the joint between the adapter and the hood, cut to length the included
foam strip to cover the bottom flange of the 10” adapter. Peel off the paper covering
the sticky side of the foam strip and stick it on the flange, leaving a space for screw
notches (smallest ones on the adapter flange).
HO0149
HO0150
1
2
Plug hood power cord into the outlet.
Mount the assembled adapter/damper and duct to
the hood using 2 no. 8 x
3
/8” sheet metal screws
(included).
See illustration at right for mounting screw locations.
NOTE: Duct and damper not shown in illustration to
ease understanding.
HJ0045
HJ0046
M
OUNTING S
CRE
W LOCATION
S
CREW HOLE LOCATION
D
AMPER HINGE
HJ0039
