BEST Range Hoods CC34IQSB, Instructions Manual

Page: 5 / 52

-
5
-
FIG. 3 FIG. 4
INDICATOR
LIGHT
HOOD CONTROL
Remote Control Functions (Fig.3)
See “Controls” section on previous page
for more information on each function. Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERY TO THE INSTRUCTION.
Battery disposal
When the batteries need to be replaced, dispose of them only and exclusively in the numerous
readily available special waste bins, especially in shops selling electronic consumer goods.
Observance of the regulations on differentiated waste collection, in particular, proper disposal of
used batteries, contributes to preventing possible negative effects on the environment and health.
REMOTE CONTROL
The remote control is linked to the hood at the factory.
If, for some reason, the link is lost - follow the directions below:
To Link Remote Control to Hood
1. Turn off hood motor and hood lights.
2. Press and buttons on the remote simultaneaously for 5 seconds, until the remote
control Indicator Light turns on (Fig.3). Release and buttons. Press and release
button to confirm the linking. At this point the remote control Indicator Light starts
flashing to confirm the link is active.
3. Within 3 seconds - press ƒ (P2) on the hood control (Fig. 4). The LED ring will light up for
approximately 10 seconds to confim that the linking process was successful.
L1
LED
RING
Press (Delay) and (Light) together to Reset Filter Alarm.
IMPORTANT: holding (Delay) for more than 3 seconds
will cause the link between the remote and hood to be lost.