BEST ACCESS SYSTEMS 1E Series, Service Manual

Page: 94 / 96

BEST ACCESS SYSTEMS
Indianapolis, Indiana
Note: Make sure that the cylinder stays in the
upright, centered position and that the spindle stays
in the spindle hole in the lock case.
2 Reinstall the lock case.
3 Check the installation by inserting the key and
turning. The key will operate the bolt freely if the
cylinder and case are in proper alignment.
3 Install core
1 Put the control key into the core and turn the key
15 degrees clockwise. See Figure 2.
2 When installing a six-pin core, slide the spacer
onto the throw pins.
3 Adjust the throw pins if needed, then put the core
into the cylinder with the control key.
4 Turn the key 15 degrees counterclockwise and
remove the key.
Figure 2 Installing the spacer (six-pin cores only)
and core
Throw pins (inside)
Core
Rim cylinder
Spacer
Counter-
Clockwise
clockwise