01-18-2001
PowerSwing US23-0922-02
18
© Copyright 2006 Besam Entrance Solutions. May not be reprinted or reproduced without permission.
Mechanical Installation, PULL/PULL-P
Operator with Arm System PULL/PULL-P
If the operator is not ordered as an
“operator package with arm system PULL”
the direction of rotation must be reversed.
Changing the Direction of Rotation
1. Mount the washers and screws in the drive shaft, one from each side.
2. Dismantle the screws (4 pcs) from the bearing sleeves on both sides.
3. Fit the tools in the holes, one from each side and turn both bearing sleeves
simultaneously approx. 165° until the setting lines in the bearing sleeves are
aligned with the setting lines in the housing.
4. Remount the four screws in the bearing sleeves and dismantle the washers and
screws.
➀
Washer and screw
➁
Screw (4 pcs)
➂
Bearing sleeve (2 pcs)
➃
Tool
➄
Setting
lines
