BESAFE iZi Combi X4 ISOFIX, Manual

Page: 386 / 395

8. After installing the lug nuts, use the jack to lower the vehicle to the ground
and exit the Jack Mode on the center display. Tighten all the lug nuts
clockwise with the lug wrench. Then, use a torque wrench to tighten the lug
nuts to the specified torque.
9. Check the tire pressure after replacement. If necessary, inflate the tires to the
rated range, and then replace the tire valve cap.
10. Properly stow all the tools, the jack, and the flat tire.
Personal Protective Equipment
The powertrain system is powered by the high voltage battery. Severe collisions
and impacts may cause electrical leakage or electrolyte leakage. Therefore,
rescue operations should be carried out by professionals who must wear personal
protective equipment.
Warning
Remove all metal objects (such necklaces and watches) before carrying out any
operation. Failure to do so may increase the risk of electric shock.
Electrical Protection
Wear the following protective equipment to avoid high voltage electric shocks:
• Rubber insulating gloves (over 500V insulation resistance)
• Goggles
• Rubber insulating boots
• Insulated tools
Chemical Protection
In case of electrolyte leakage, wear the following protective equipment to prevent
skin and facial injuries:
• Protective face shield
• Chemical-resistant gloves
High Voltage Cutoff
To cut off the high voltage circuit, disconnect the emergency high voltage
cutoff plug (located under the hood and near the coolant reservoir), and then
Emergency Rescue
384