CDP Installation Manual
16
iii.
Refer to dolly labeling to turn the input shaft the correct direction so that the
system raises
b.
Use the included keyed-socket bit with a drill to drive one input shaft as shown in Figure
17
Figure 17
–
Gear box and keyed-socket bit
c.
When the system is 1/3 of the way raised, move the stabilizer bar to the bottom of the
dollies as shown in Figure 18
Figure 18
–
Stabilizer Bar connected to bottom of dollies
d.
Continue to raise the system using drill
e.
Check frequently to ensure the lifting shafts, Figure 20, DO NOT come in contact with
the top of the weldment window, Figure 19. NOTE: This is critically important, as
contact between these two elements can lead to damage that could put the user or
device in serious harms way