CDP Installation Manual
12
4.
Warnings of using the CDP Dollies to move the base
a.
See videos shared by Bertec
b.
NOTE: Not following dolly instructions can lead to unsafe situations for both the
installer and the equipment. Be careful, go slow especially when driving the dollies up
or down
i.
NEVER allow the dolly lifting shafts to touch the top or bottom of the window
that they run in inside the dollies
ii.
Follow instructions to initially attach the stabilizer bar to the top of the dollies
initially while lifting, then moving it to the bottom of the dollies when the
system is half way raised. NEVER roll the CDP system around without the
stabilizer bar at the bottom of the dollies.
c.
Getting CDP Base into Optimal Vertical Position
i.
These dolly instructions should be used IN ADDITION to the dolly instructional
videos
ii.
Attach dollies like normal, making absolutely sure to get the correct dolly on the
correct side of the system. This means that the input shaft of the gearbox and
the linkage arm at the bottom of the system are on the same side of the dolly,
see below (the blue vertical line is the midline of the dolly). Both the input shaft
at the top and the linkage arm at the bottom are on the RIGHT side of the dolly
midline. As a note, on the other side of the system, they will both be on the
LEFT. This should be true whether the system is in a raised position or a
lowered position.