Bernina Q 16, User Manual

Page: 42 / 78

Setting up the machine
42
> Pull in a wide arc around the thread guide (6) in the direction of the arrow.
6
> Open the service door and check whether the thread is positioned between the two rear thread tension
discs. If not, repeat the previous step.
> Close the service door.
> Guide the thread on the right-hand side of the machine in the direction of the arrow around the thread
regulator (7).
> Guide the thread up and thread into the take-up lever (8) from the back to the front.
> Guide the thread down and into the left opening of the thread guide underneath the service door.
> Guide the thread from the right into the thread guide on the needle bar.
> Insert the thread into the needle threader slot.
> Thread it into the left needle using the needle threader.
Threading the right thread
Prerequisite:
• The double needle is inserted.
• The needle is in the upper position.
• The presser foot is raised. This is IMPORTANT so that the thread can be inserted between the thread
tension discs.
> Place the spool on the right spool pin.