Berner 217709, Original Instructions Manual

Page: 18 / 239

18 | English
1 609 92A 101 • 9.6.15
Technical Data
The technical data of the machine are listed in the
table on page 221.
The values given are valid for a nominal voltage [U]
of 230 V. For different voltages and models for spe-
cific countries, these values can vary.
Declaration of
Conformity
We declare under our sole responsibility that the
product described under “Technical Data” is in
conformity with all relevant provisions of the direc-
tives 2011/65/EU, until 19 April 2016:
2004/108/EC, from 20 April 2016 on:
2014/30/EU, 2006/42/EC including their amend-
ments and complies with the following standards:
EN 60745-1, EN 60745-2-3.
Technical documents at:
Berner Trading Holding GmbH
Bernerstraße 6
74653 Künzelsau
09.06.2015, Berner Trading Holding GmbH
Bernerstraße 6
74653 Künzelsau
GERMANY
Noise/Vibration Information
The measured values of the machine are listed in
the table on page 221.
Sound emission values determined according to
EN 60745-2-3.
Vibration total values a
h
(triax vector sum) and un-
certainty K determined according to EN 60745-2-3.
The vibration level given in this information sheet
has been measured in accordance with a standard-
ised test given in EN 60745 and may be used to
compare one tool with another. It may be used for
a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or insertion tools or is poorly main-
tained, the vibration emission may differ. This may
significantly increase the exposure level over the
total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not ac-
tually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The in-
structions for each action objective are shown aside. Depending on the type of application, various in-
struction combinations are required. Observe the safety instructions.
Armin Hess
Chairman of the Management Board
Action Figure Please observe Page
Grinding, preparation 1 222 – 223
Cutting, preparation 2 224 – 225
OBJ_BUCH-2484-002.book Page 18 Tuesday, June 9, 2015 11:18 AM