Notes:
Please prepare the measuring very carefully. Keep surfaces clean. The caliper should regularly be cleaned with a dry cotton-cloth. Do not
use white gas. Do not expose the caliper to direct sunlight, ultraviolet rays or extreme temperatures. Prevent it from any shock and do not
immerse the caliper in any liquid. For maintenance we recommend maintenance tissues.
High voltage etching or engraving can destroy the electronic chip, no warranty will be given!
Never dismantle the caliper. The battery should be taken out, if not in use for a long time.
Do not dispose of batteries in domestic waste. Please give it to a special collecting depot.
1. Function:
1. ON/OFF
2. Origin resetting
3. Metric / Inch switch
4. Thumb roller
5. Battery cover
6. Fixing screw
7. Display
8. Depth Gauge
9. Measuring jaws for outside measurement
10. Measuring cross-tips for inside measurement
11. Data output
2. Specifications:
Measuring range:
0 - 150 mm/6“
Max. error:
± 0.02 mm
Resolution:
0.01 mm, 0.0005“
Max. operational speed:
± 1.5 m/sec.
Repeatability:
± 0.01 mm
Power supply:
Battery (3V, type CR2032)
Storage temperature:
+ 0°C to + 40°C
Humidity range:
0% to 80%
3. Battery replacement:
Remove the battery cover on the bottom carefully. Remove the old battery. Replace the new battery with the positive (+)
facing up into the battery compartment without damaging the contacts. Now close the battery cover very carefully.
4. Trouble shooting:
Trouble
Cause
Correction way
No display
1. Voltage too low
2. Battery has no contact
1. Replace battery
2. Clean contacts
LCD does not count
Faulty Display
Fault in electronic
Take battery out and replace after 30 sec. or use new
battery
Display flashing
Voltage too low
Replace battery
5. Function:
Description
Remark
Preparing
Open fixing screw, clean the measuring
faces and switch the caliper on
Origin resetting
Keep measuring faces to contact and
press (ZERO) key
You can reset the caliper at any position and it remains
until it is changed or battery is replaced
MM/INCH switch
Press (inch/mm) button to be in MET-
RIC or in INCH mode
6. Data output
The output of the displayed value to e.g. MS Excel is possible. For optimal data transfer, we recommend a DT-Box.
7. Calibration:
On request we can make an optional calibration according to DIN 862.
202040.3|20140819|AM
Operation manual
Electr. Digital Caliper DIN 862
