Shutter actuator 4gang 6A 230V manual
RMD
75314013
Technical
Documentation
© Gebr. Berker 2005
Version: 10.05.2005
Page: 11 / 17
(Subject to prior change)
75314013.doc
Part 7
Manual control
The actuator as delivered has the manual control mode already enabled. The four keys on the device front
panel permit comfortable local operation of the up to 4 output channels also without bus voltage being
present. The different operating states are indicated by up to 11 red LEDs. For manual control, the mains
supply must be on.
A1
A2
A3
A4
OFF
Activation of manual control and operation:
The manual control mode can be activated temporarily or permanently.
Permanent manual control:
Activation:
1. Press the "
" key for at least 5 seconds.
2. The red LED beside the "
" key lights up statically. The actuator is now permanently
in the manual control mode, control via the EIB is disabled and all output channels are
stopped.
Operation:
A short press (< 1 second) on the "
" key selects the output channel which is to be
operated by manual control. The two status LEDs (
) of the output selected in the
LED array start flashing. Pressing the select key repeatedly permits switching between the
outputs (A1
→
A2
→
A3
→
A4
→
A1
→
...). If the actuator works in 2x2-channel
operation, the outputs are automatically combined and controlled in common. (A1 / A3
→
A2 / A4
→
A1 / A3
→
A2 / A4
→
A1 / A3
→
...).
The "
" and "
" keys can be used to control the selected output channel and to modify
the switching status and the sense of movement. The LEDs beside the keys indicate the
switching state of the selected channel. The switching states of non selected outputs are
indicated as for 'normal' bus operation by means of the LEDs of outputs A1 thru A4 in the
LED array.
Deactivation:
- by pressing the "
" key for at least 5 secs. until the corresponding LED goes out or
- by bus reset or reapplication of bus voltage (return of bus voltage), or
- by switching off the mains voltage.
Master stop function:
When the actuator is in the permanent manual control mode, all output channels can be shut off at the
same time (stop).
A press on the "OFF" key executes the stop function. All relays are switched off immediately.
The master stop function is available in the permanent manual control mode only!
