BERKEM GALVALINK 302B, User Manual

Page: 13 / 36

01/12/14 Manuale Uso GALVALINK_302B_v3_14 EN Completo 13
8.2 Mechanical installation
The machine can be rested on a perfectly flat and horizontal surface, that is dry and clean. The machine
can have the rear resting against a wall; we recommend that you leave at least 1 m around the machine
to conveniently carry out all cleaning operations without having to move the machine. Furthermore, you
are advised to have an open space on the front of the machine as wide as possible, to facilitate the
operator's work.
The installation layout of the machine is outlined in the Attachment.
8.3 Electrical connection
The machine, to be powered, must be connected to an electrical system installed according to the safety
standards in force and meeting non-flammability requirements. Before carrying out any connection, you
need:

to make sure that the data relating to the power line correspond both to those indicated on the
identification plate on the machine and the electric box and to those outlined in the Technical
Data in this manual;

to make sure that the power cables have a minimum section of 2.5 mm
2
.
Ensure that, upstream of the electrical circuit socket, an automatic circuit breaker switch is connected
and that the circuit has a grounding connection correctly connected to the power socket, which must be
suitable for connection with the plug on the machine cable. Ensure the machine is not powered.
To power the machine, insert the plug of the power cable on the system socket.
In the event of a fault or malfunctioning, contact qualified staff.
9.
ASSEMBLING AND DISMANTLING THE MACHINE
9.1 Initial assembly
The machine is supplied ready to work.
The only operation to carry out is to prepare and fill the tanks with the electrolytic liquids as outlined in
point 6.2.
10.
PREPARING THE MACHINE TO WORK
10.1 General information
The machine is supplied ready to work.
10.2 Checking any damage on the machine
When you remove the packaging from the machine, carefully check each part and ensure that there was
no damage during transport. If damage is found, firstly contact the carrier company, then the retailer or
the manufacturer. Also ensure you have received the machine with all its parts.
10.3 Removal of the blocks
The machine is delivered without blocked parts, therefore no block removal is required.
10.4 Cleaning the machine
Clean the machine carefully before operating it, removing the dust and any foreign or dirty substances.
To clean the machine, the operator must wear gloves, goggles and an apron. The machine should be
cleaned using a soft cloth and, if necessary, brushes and tools in hard plastic, to avoid scratching the
tanks and any other parts.