12 in 1 Steam Cleaner Max
H008
Instructions for Use
Please read and retain these instructions for future reference
v001: 24/08/20
Page No. 10
7.
Select one of the following Steam Regulator positions:
1 – Low – 2-Medium, 3-High and 4-Hot spray
1-Low and 2-Medium Setting: Ideal for cleaning all hard floors, such as
linoleum, ceramic , marble, wood etc
3 High Setting: Ideal for cleaning bathrooms, kitchens, window sills, car
wheels etc. You can change the steam regulator position and change the
steam output while operating the steam cleaner.
8.
Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt loosened by the
steam. Apply steam liberally. Keep a towel handy and wipe away any excess water that may accumulate.
9.
When the steam cleaner stops emitting steam, simply turn OFF and unplug the appliance, refill the water
tank and continue cleaning.
WARNING
Never leave the steam cleaner unattended while plugged in.
For best results:
1.
Sweep or vacuum floor prior to using the steam cleaner.
2.
To avoid puddling of water, the micro fibre cloth must be clean and dry for use. To replace the cleaning
cloth proceed as follows: Let the cleaning cloth cool down, remove cloth from unit, replace with a new
micro fibre cloth and continue use. Select low steam regulator position.
3.
To sanitize the area of your floor, leave the Steam Cleaner at high steam setting over the steam area for
about 10 seconds but no longer than 15 seconds.
Note:
Do not carry out this procedure on heat and steam sensitive floors.
IMPORTANT
Never steam at one spot for too long. This can cause floor surface damage.
Do not put hands or feet under the steam cleaner. The unit gets very hot.
