12 in 1 Steam Cleaner Max
H008
Instructions for Use
Please read and retain these instructions for future reference
v001: 24/08/20
Page No. 9
6.
Once the unit has been fully assembled and filled with water, plug in the power cord to an earthed
electrical outlet. The RED light – Power indicator will indicate when power is on. Power Switch (O/I) is on
the OFF (O) position.
Wait for the Ready-to-use indicator to turn Green – approximately 20-30 seconds. GREEN light will turn
on when the steam cleaner is ready for use.
When the Ready-to-use indicator light turns Green turn the power switch (O/I) to the ON (I) position.
The steam cleaner will start emitting steam.
To stop emitting steam turn OFF (O) the unit by turning the power switch (O/I) to the OFF position again.
If the power switch (O/I) is turned prior to the Ready-to-Use light indicator turning green, water from the
previous use will not be heated and will be forced out by present steam and will cause puddling.
This may also happen if the power switch was left in the ON (I) position from the previous use and the unit
was disconnected by unplugging only. Make sure to turn the unit OFF after each usage and then disconnect
from the electrical outlet so the unit is in the OFF (O) position when used next time.
Replace the water tank cap and turn clockwise
approximately 90 ° to the “CLOSE” position until the cap is
tightened securely.
The Steam Cleaner uses tap water. However in areas with
hard water, distilled water should be used for better
performance.
Make sure the copper cone inside the water tank is always
submerged in water (as illustrated) while operating the
Steam Cleaner.
Note:
Never put cleaning detergent or scented products into the
steam cleaner. This will make the operation unsafe and
damage the unit.
