Beretta 20039694, Instruction Manual

Page: 12 / 36

12
5. Fit the printed circuit board in the base of the control
box and fix it in place with the two screws.
6. Break off the pre-formed tabs and fit the cable
clamps to the detachable partition.
7 Wire up the printed circuit board according to the
connections table (see table 4).
8. Configure the printed circuit board by means of the
jumpers (see table 2).
9. Re-position the detachable partition with the cable
clamps inside the base of the control box. Make sure
you fit it the right way around. The bevelled edge of
the partition must face outwards towards the cover,
as shown in the figure alongside.
10. Close the box, taking care to align the cover with the
base so that the knob engages with the trimmer on
the board.
b
The trimmer shaft has a flat that engages with
the knob (see figure). To make sure that the knob
engages with the trimmer on the printed circuit
board when you close the box, it is essential to
align the flat on the trimmer shaft with the corre-
sponding flat in the adjuster knob. Align the cover
over the base and gently turn the knob until you feel
it engage with the trimmer shaft. Only then push the
cover fully home on to the base.