14
ASSEMBLY
Choose between the three different ways of securing
the control box support (item 1).
Insert the control box (item 2) in the support.
Connect the connectors of the wire on the control box
to the three corresponding electric motors (the motor
for the chute, for the deflector and for the belt
tensioner).
Make sure the connectors are well connected
together.
Install the control box
Install an engine circuit breaker: find the wire (item
1) that supplies the engine’s booster coil and
disconnect it.
Assemble the connectors (items 2 & 5) of the
control box into the engine connectors (items 3 & 4)
as shown.
IMPORTANT:
the control box is equipped with a red
emergency switch*. Push down on this button if it
becomes necessary to stop the engine quickly.
*Which is relayed to the connectors (items 2 & 5).
NOTE:
The emergency switch must be pulled out to
start the engine of the snowblower.
Install a circuit breaker for the engine
Connect the red wire to the vehicle's positive battery
post (item 1) and the black wire to the negative
battery post (item 2).
Tie the wires to the vehicle with the nylon tie wraps.
NOTE:
These wires will stay attached to the vehicle.
Connect the wires to the battery
STEP 5
CONTROL BOX INSTALLATION:
