11
ASSEMBLY
BELT INSTALLATION
NOTE:
See belt replacement instructions in the
maintenance section of the rotary broom owner’s
manual.
Remove the belt guard.
Install the belt on the drive mechanism pulley (item 1)
as shown.
Reinstall the belt guard.
TIP:
Because of strong tension on the spring and to
facilitate installation of the belt, put the broom on the
ground and remove the belt from the engine pulley.
Install belt
ROTARY BROOM INSTALLATION:
Refer to Rotary Broom owner’s manual, parts
breakdown section for parts identification.
VERIFY BELT ROUTING:
-Lower the rotary broom to the ground and let it run
for a few seconds under supervision.
-Disengage the rotary broom and stop the engine.
-Check the belts to make sure they are well inserted
on the pulleys and have not flipped on their sides in
the pulleys and that they do not touch the belt
guides.
Install rotary broom
Item 1: Drive mechanism pulley
Item 2: Rotary broom pulley
9
WARNING
9
FOR YOUR SECURITY:
Read the Rotary Broom owner's manual for
safety precautions and rules.
Follow the assembly and operation instructions.
9
WARNING
9
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Attach the rotary broom to the subframe as shown.
Make sure the rotary broom is pushed in until locked
into place by the springs (item 1).
9
CAUTION
9
Never use the Rotary Broom without the belt
guard.
9
WARNING
9
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch is
disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
