6
Install handle support
ASSEMBLY
Install the handle support (item 1) on the left hand side
with a 3/8 x 1 1/4" hex bolt (item 2) and flange nut
already in place, a 3/8 x 1" hex bolt (item 3) and flange
nut.
Tighten firmly.
Insert the plastic grommet (item 4) in the handle support.
Install the handgrip (item 5) as shown.
NOTE: For the G-100 model
Unscrew the bolts (items 2 & 6) from each side and
raise the pulley support (item 7). Secure it in the second
set of holes (item 8) (1.00’’ higher) with the same bolts.
SUBFRAME INSTALLATION:
Slide the subframe under the tractor between the
front and back wheels on the left side.
Lift the back part of the subframe and hook the
supports (item 1) (as shown) on the mounting pins
(item 2).
Lift the front part of the subframe between the tractor
supports (item 3).
Secure in place in the square holes or round holes
(item 4) depending on the model of tractor with two
0.50 x 1.25" pins (item 5) and two 3mm hair pins
(item 6).
IMPORTANT:
Make sure the bolt (item 7) is 7 1/2’’ to 8 1/4’’ from
the ground.
NOTE:
If the holes are not aligned, loosen the
supports, install the pins and retighten the support
bolts tightly.
If the tractor supports (item 3) are too narrow, loosen
the bolts that hold the heat shield.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Install the subframe