9
ASSEMBLY
SUBFRAME INSTALLATION:
Slide the subframe under the tractor between the
front and back wheels on the left side.
Lift the back part of the subframe and hook the
supports (item 1) (as shown) on the mounting pins
(item 2).
Lift the front part of the subframe between the tractor
supports (item 3).
Secure in place in the square holes or round holes
(item 4) depending on the model of tractor with two
0.50 x 1.25" pins (item 5) and two 3mm hair pins
(item 6).
IMPORTANT:
Make sure the bolt (item 7) is 7 1/2’’ to 8 1/4’’ from
the ground.
NOTE:
If the holes are not aligned, loosen the
supports, install the pins and retighten the support
bolts tightly.
If the tractor supports (item 3) are too narrow, loosen
the bolts that hold the heat shield.
Install the lift arm (item 1) to the lift arm extension
(item 2) with two 5/16 x 3/4" bolts and flange nuts.
Tighten firmly.
Install the handgrip (item 3) as shown.
Pull lift arm towards the rear of tractor.
The arm should be 1" outside the mud guard and 2
1/2" above the tire. If not, adjust the arm by
unscrewing the bolt (item 4).
IMPORTANT:
When adjusted properly, tighten bolt
(item 4) very firmly with hinge handle or a torque
wrench at 85-90 lbs/ft.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Install the subframe
Install lift arm