15
ASSEMBLY
Lower the tension arm (item 1) to release the tension
on the helper spring (item 2) to facilitate snowblower
installation.
Install the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the springs (item 3).
NOTE:
Before installing the belt, unhook the spring (item 2)
by sliding the spring link (item 4) off the tension arm
(item 1).
Put the spring on the ground on the left side.
STEP 2
SNOWBLOWER INSTALLATION:
Refer to snowblower owner’s manual, parts
breakdown section for parts identification.
WARNING
FOR YOUR SECURITY:
Read the snowblower owner's manual for safety
precautions and rules.
Follow the assembly and operation instructions.
WARNING
TO PREVENT INJURIES:
Stop the motor.
Apply parking brakes.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
Install the double pulley support (item 1) as shown on
the male hitch by using two 5/16 x 1" bolts (item 2)
and flange nuts. Tighten the bolts firmly.
CAUTION
TO PREVENT INJURIES:
Always raise the attachment to reduce the
tension on the spring before applying or
releasing tension on the helper spring. Firmly
hold the handle when you release the tension
because the arm will kick back due to the tension
on the spring.
Install the snowblower
Install pulley support