7
ASSEMBLY
Install the push bar (item 1) by inserting it into the sleeve
(item 2) welded on the pivot support (item 3).
Install the other end in the fork (item 4) of the lift arm
with a pin (item 5), the head on the inside and secure
with a 2.5 mm hair pin (item 6).
Install the handle support (item 1) on the left support
(item 3) with two 5/16 x 3/4’’ hex. bolts (item 2) and
flange nuts.
Install the plastic grommet (item 4) on the handle
support (item 1).
This subframe includes the front supports in order to
install the Berco cab.
Install the 5/16" x 1/2’’ square head socket set screws
(item 5) in the tubes (item 6) welded on each support.
Install the handle support
Install the push bar
