9
ASSEMBLY
Install the drive mechanism under the tractor by hooking
the back part (item 1) on the tractor pins (item 2).
(Remove the flat washers (item 3) and the hair pins
(item 4) to facilitate installation).
Secure the front part of the drive mechanism by
inserting the pin (item 5) from the left hand side, in the
holes (item 6) of the supports and secure with a 2.5 mm
hair pin (item 7).
Secure the rear part of the drive mechanism by installing
the original flat washer (item 3) and hair pin (item 4) on
the tractor pins (one on each side of tractor).
In order to facilitate belt installation, remove belt from the
large pulley, insert it around the motor pulley, and then
on the large pulley.
NOTE:
Make sure the clutch mechanism works well.
MANUAL CLUTCH:
Make sure when you disengage the clutch, that the
snowblower or the broom stops turning immediately.
Make sure the belt does not touch in any way the belt
guides when the clutch is engaged. (
DO THIS
VERIFICATION WHEN THE MOTOR IS TURNED
OFF.
Install the drive mechanism
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
